Request Information
The 12V Battery Charger charges a 12V lead-acid battery as well as other battery chemistries. It is designed for mounting in a vehicle or in a stationary engine and managed heat dissipation so no fan cooling is required. It accepts 120VAC/220VAC line power. The charger monitors a remote battery temperature sensor for safe operation and prevention of battery overheating. It transmits charger condition, line connection status, battery voltage, and charge current over CAN bus. Electronic Assistant configures the charger to suit the application. Another model based on the charger design acts as a power supply.
Unit of Measure

Technical Specifications

 N/A AC/DC Power Supply Mode CAN bus (SAE J1939) High Efficiency With Electronic Assistant

Order Code

 N/A P/N: AX090550

Operating Voltage

 N/A 120 VAC, 208 VAC or 240 VAC nominal
95 to 260 VAC, 45/65 Hz power supply range
(60 Hz units and 50/60 Hz units)
Power factor correction >0.99 @ 120VAC; >0.98 @ 240VAC
Two internal fuses L and N, 8A, 250VAC

Communications

 N/A 1 CAN port (ISO 11898 Compatible)
Termination resistor is not installed.
SAE J1939 stack; Baud Rate: 250 bit/sec

Control Logic

 N/A Standard Embedded Software
Battery charger setpoints can be viewed and configured through the CAN bus using the Axiomatic Electronic Assistant (EA).

Enclosure

 N/A 11.83 x 8.74 x 3.88 inches (300 x 222 x 98 mm)
L x W x H excluding power cable assembly ACD12 Die Cast Aluminum Enclosure and Lid, Hard Anodized to MIL-A-8625
Type II Class I Clear Hard Anodize
Molded EPDM Gasket
Molex Connectors (See electrical connections.)

Connections

 N/A 1 4-pin Molex 194280006 (Mates with Molex 194180004 Receptacle).

Protection Rating

 N/A IP67

Operating Temperature

 N/A For Input >170VAC: -40 to 70 ºCFor Input 90 to 170 VAC: -40 to 60 ºCFor Input >170VAC: -40 to 158 ºFFor Input 90 to 170 VAC: -40 to 140 ºF

Power Supply Mode

 N/A 5VDC - 24VDC Output, Up to 15A
User Configurable

Battery Charger Mode

 N/A Current: 0.5 – 25 ADC Depending on the Charging Mode and User Configuration Voltage: 10 – 15 VDC Depending on the Charging Mode and User Configuration

Applications

 N/A

Off-highway Vehicles, Lift Equipment, Electric Vehicles, Fleet and Utility Vehicles, Emergency Vehicles.

Power Gensets, Oil and Gas Equipment, Electric Utility Substation Switchgear

Datasheet

 N/A AX0905X0 Datasheet

User Manual

 N/A AX0905X0 User Manual

STEP Files (3D)

 N/A AX090550

Compliance

 N/A LVD - DoC - All
RoHS - DoC - All

Accessories

 N/A , Axiomatic Electronic Assistant KIT (USB-CAN Converter, USB-A to USB-B Cable, CAN Cable, Installation Instructions)