The 12V or 24V Battery Charger charges a 12V lead-acid battery as well as other battery chemistries. It is designed for mounting in a vehicle or in a stationary engine and managed heat dissipation so no fan cooling is required. It accepts 120VAC/220VAC line power. The charger monitors a remote battery temperature sensor for safe operation and prevention of battery overheating. It transmits charger condition, line connection status, battery voltage, and charge current over CAN bus. Electronic Assistant configures the charger to suit the application. Another model based on the charger design acts as a power supply.
Unit of Measure
Technical Specifications |
N/A CAN bus (SAE J1939) High Efficiency With Electronic Assistant |
Order Code |
N/A P/N: AX090560 |
Operating Voltage |
N/A
120 VAC, 208VAC or 240VAC nominal 95 to 260 VAC, 45/65 Hz power supply range (60 Hz units and 50/60 Hz units) Power factor correction >0.99 @ 120VAC; >0.98 @ 240VAC Two internal fuses L and N, 8A, 250VAC |
Communications |
N/A
1 CAN port (ISO 11898 Compatible) Termination resistor is not installed. SAE J1939 stack; Baud Rate: 250 bit/sec |
Control Logic |
N/A
Standard Embedded Software Battery charger setpoints can be viewed and configured through the CAN bus using the Axiomatic Electronic Assistant (EA). |
Enclosure |
N/A
11.83 x 8.74 x 3.88 inches (300 x 222 x 98 mm) L x W x H excluding power cable assembly ACD12 Die Cast Aluminum Enclosure and Lid, Hard Anodized to MIL-A-8625 Type II Class I Clear Hard Anodize Molded EPDM Gasket Molex Connectors (See electrical connections.) |
Connections |
N/A 1 4-pin Molex 194280006 (Mates with Molex 194180004 Receptacle). |
Protection Rating |
N/A IP67 |
Operating Temperature |
N/A For Input >170VAC: -40 to 70 ºCFor Input 90 to 170 VAC: -40 to 60 ºCFor Input >170VAC: -40 to 158 ºFFor Input 90 to 170 VAC: -40 to 140 ºF |
Power Supply Mode |
N/A
5VDC - 24VDC Output, Up to 15A User Configurable |
Battery Charger Mode |
N/A Current: 0.5 – 15 ADC Depending on the Charging Mode and User Configuration Voltage: 10 – 30 VDC Depending on the Charging Mode and User Configuration |
Applications |
N/A
Off-highway Vehicles Lift Equipment Electric Vehicles Fleet and Utility Vehicles Emergency Vehicles Power Gensets Oil and Gas Equipment Electric Utility Substation Switchgear |
Compliance |
N/A
RoHS - DoC - All |
Datasheet |
N/A
AX0905X0 Datasheet |
User Manual |
N/A
AX0905X0 User Manual |
STEP Files (3D) |
N/A
AX090560 |
Accessories |
N/A
AX070502, Electronic Assistant KIT (AX070501 USB-CAN, 2 Cables, Installation Instructions) |
